-
Scratches. Shallow scratches can be eliminated by heating with special equipment (up to 350-400 ° C). The surface should be heated at a distance of at least 20 cm from the defect, without lingering for a long time in one area. Heating works well on glossy coatings, while on matte ones it can give an undesirable shine. Deeper scratches are more difficult to eliminate, for this it is necessary to re-tighten the corresponding body element. In some cases, you can imperceptibly insert the necessary section of the new film and combine it at the joints.
-
Bloating. The appearance of unwanted bubbles that violate the appearance of the car body may be due to poorly installed film or prolonged exposure to direct sunlight. You can eliminate the defect by carefully peeling off the area, degreasing and fixing it back. If a bubble has formed in the center of the part, you can pierce it and mask this place.
-
Peeling off the edge of the film. This can happen under the high pressure of a water jet during washing. This defect is easy to eliminate - it is necessary to separate the detached area, clean, degrease and install it back.